Peco Power Feed Joiners Code 75 and Code 83 Track

PL81 Peco Power Feed Joiners Code 75 and Code 83 Track.

These will help address the worries of soldering that many modellers' have: they're the safe, clean and tidy way of bringing power to the track. Supplied in packs of four pairs, each joiner has a short length of wire securely pre-soldered to it. The modeller just has to substitute the standard metal joiners for a pair of these where the power feed is required, and pass the wires down through pre-drilled holes in the baseboard. With approximately 8 inches (204mm) of wire on each one there should be plenty of length available to go through most baseboards. In turn these wires can be connected to longer runs of wiring under the baseboard and be taken back to the outlet terminals of the transformer. See the illustration.

PECO also produce the wire and cable connecting blocks to complete the set-up. These Power Feed Joiners will also save time and help avoid accidental heat damage to the trackwork when using a soldering iron.

Each single pack contains 8 pre-wired joiners (4 red, 4 black)

Suitable for HOn3 Code 70, OO/HO Code 75, HOm Code 75 and ""83 LIne"" HO Code 83 rail profiles

*Note: the joiners in this pack are supplied as pair joined together. The modeller just has to snap them apart.